X L T (X-Press Lift Tool )

Landing Gear Cranking GONE!

The XLT Drill System eliminates the landing gear cranking. Portable drill with connectors on the drill and the trailer eliminate all torque with a 5-10 minute install per trailer is all it takes for a fleet to eliminate this task and provide a safer operating environment. The 15 seconds of landing gear work now required with the XLT Drill provides for a better rested driver and goods getting to their final destination sooner and safer.

As shown below other options are available without requiring any product installation on each trailer.

XLT Kit Contents

XLT on trailer - ready to raise it

I-Beam Trailer TED

Did you know?

A shuttle driver making 2 trips a night with pups will operate the landing gear at least 16 times a night.

Many companies require dropping trailers at the dock to prevent fork lift accidents. XLT makes that quick & safe.

Why the X-Press Lift Tool ?

>>> Eliminate arm, shoulder and back strains or injuries
>>> Rested driver means a safer driver
>>> Much less time on task means less time in the weather
>>> Driver may extend employment by delaying retirement
>>> Reduce turnover by eliminating this undesired workload
>>> Help on meeting the government HOS requirements
>>> Reduce landing gear wear/tear by eliminating road impacts
>>> No more 5th wheels damaging front of trailer
>>> Fleet installation of TED safety plate is 5-10 minutes per trailer
>>> ROI of 2 months

Call an XLT System specialist @ 214-884-8258 to answer questions or to get install started or

WHAT? The X-Press Lift Tool is the product which eliminates the manual cranking of landing gear. Patented, high-torque specially designed drill to raise/lower a trailer in mere seconds SAFELY.

TORQUE? XLT needs power to raise a trailer and torque is a by product. To ensure 100% safe use, TEDs (Torque Elimination Devices) have been designed. For fleets, one attached to the drill and one on the trailer interlock to eliminate all the torque. While not required, the use of this TED method guarantees a quick and safe environment and recommended for fleets. At fleet price of $80 per trailer, safety is inexpensive and quick with the XLT products. The other methods, described below, will be safe if used properly.

SAVINGS? The savings in time is obvious when the landing gear task is now less than 15 seconds. Other savings are just as important: no more injuries, rested driver, time in inclement weather reduced, reduction of landing gear maintenance.

INSTALLATION? Fleet installation is a simple 5-10 minute installation per trailer using the TED I-Beam product. No installation required for the other two use scenarios. Only work effort is removal of the crank handle on the trailer.

ROI? At a cost of $500 a kit, a one year warranty, 20-50 uses of drill on one battery, ROI is calculated to be 2 months. Eliminating an injury cannot be quantified but can be priceless!

HOW? The handle on the trailer is removed and a latch pin is inserted into the landing gear shaft. This allows for the specially designed quick connect coupler, to attach to the shaft and rotate it. XLT Drill replaces all manual work and safely eliminates arm, back and shoulder strains (and time).

X L T (X-Press Lift Tool )Landing Gear Cranking GONE!